Information for the public:
- Expert statement on the automation of evaluating the brake test on a roller brake tester: The procedure by which a vehicle inspection technician evaluates brake performance is governed by methodological guidelines of the Ministry of Transport, including the calculation formulas that must be used to assess, for example, whether the braking effect is sufficient. For the calculation, any technical means or aids may be used. Since 2022, we have gradually made available in the information system for technical inspections a function for the automatic calculation of the parameters of braking effect, fluctuation and imbalance based on values transferred to it from roller brake testers. This function is in test operation and its use is not yet mandatory for vehicle inspection technicians. The correctness of the calculations produced by this function was independently assessed by the University of Žilina. We have published the expert opinion, concluding that the calculations are correct and comply with regulatory requirements, on our website. From January to August 2025, up to several thousand cases were identified in which, based on the values transferred from roller brake testers, a serious or dangerous defect of the service or parking brake should have been marked in the technical inspection report, but the technician did not mark it. All these cases could be prevented by making the use of the automatic calculation function mandatory. However, until the regulations are amended, technicians may continue to use other means to perform the prescribed calculation and assess whether the vehicle's brakes are in order.
- Comparison of how vehicle technical inspection stations (STK) and emission inspection stations (SEK) operate in selected European countries (analysis of the Parliamentary Institute of the National Council of the Slovak Republic, 22/11/2024). The Parliamentary Institute of the National Council of the Slovak Republic published an interesting analysis comparing how STK operates in Slovakia and in other European countries. It contains many interesting and for some perhaps surprising findings. For example, in several European countries, state-run STK operate alongside private ones, and in one country (Malta) STK are exclusively state-run. EU legislation does not treat vehicle inspections as a normal commercial service, but places a direct obligation on Member States to ensure that inspections are carried out properly, while allowing them to delegate the performance of this service to private entities. In that case, the Member State must supervise them so that inspections are carried out properly and in accordance with the rules. In many countries, similarly to Slovakia, such supervision is carried out in cooperation between the state and non-state companies (France, Germany, Croatia). Almost half of the states also use a method known as “mystery shopping” for supervision, i.e., inspecting a vehicle with pre-known defects. Likewise, information systems for data collection are, again similarly to Slovakia, operated in other countries by non-state companies; in some places private companies even own the inspection data stored in them. It is not uncommon for user access to these systems to be charged, sometimes even not only for entering data but also for reading data from them. More than half of the countries surveyed have introduced various forms of camera systems at STK; for example, in Sweden all STK operators use them voluntarily beyond the obligations set by national regulations. All states have mandatory examinations for technicians; everywhere they are conducted in person and are provided by authorised organisations with the participation of state-appointed exam commissioners, exactly as in Slovakia. As for the scope of inspection, EU legislation defines a mandatory minimum, and Member States may extend the assessed requirements or detected defects beyond this minimum. Besides Slovakia, almost all surveyed states make use of this option; the only exception is Italy.
- Hudec, J., Šarkan, B.: Effect of Periodic Technical Inspections of Vehicles on Traffic Accidents in the Slovak Republic (Slovak translation) – a study published in the scientific journal of the University of Žilina, Komunikácie / Communications, which, based on statistical data from Slovakia, demonstrates the impact of technical inspections on road traffic safety. According to its conclusions, regular technical inspections have a measurable positive effect on the number of traffic accidents due to technical defects of vehicles and therefore have demonstrable justification. However, during technical inspections in Slovakia some defects critical from a safety perspective are detected less often, especially those related to wheels and tyres. A possible explanation is that the supervision methods predominantly used so far have not been able to detect relevant violations of regulations during inspection of these parts sufficiently effectively. By contrast, other parts of vehicles with a critical impact on safety, primarily brakes and external lighting devices, were covered sufficiently by supervision. An interesting finding is also that for vehicles of categories M1 and N1 (mainly passenger cars and vans up to 3.5 t) older than 10 years, the overwhelming majority (up to 87%) of traffic accidents caused by poor technical condition occur in the second half of the two-year validity period of the regular technical inspection, on average about half a year before its expiry. By shortening the inspection intervals for vehicles of these categories older than 10 years by half, i.e. to one year, the study suggests that the number of traffic accidents due to technical defects in this group of vehicles could decrease by at least half.
- Information about registration for car repair shops for entering confirmations of repairs after serious traffic accidents into the technical inspection information system
- Answers to the most frequently asked questions about technical inspections for national approval of individual vehicles with limited operation (“farm plates”)
- The application has moved STK towards smart solutions (article about the mSTK application, which we develop for use in technical inspections together with the Institute of Automotive Mechatronics of the Faculty of Electrical Engineering and Information Technology of STU in Bratislava)
- Form to fill in the technical data of an individually approved vehicle with limited operation (“farm plates”), updated 12/03/2020